Dave,
If you can source a dent free OEM apron that is the best way to go.
But dont be surprised if you do have some issues with the fit.
My experience tells me once there is damage such as this the geometry will
never be the same no matter what you do.
As far as the tear, that will not only have to be pounded out, it will have to
be either welded or brazed.
But the repair would be a challenge any decent body guy would take on I am
sure.
Best of luck.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|