On Wednesday 30 January 2008 04:25 pm, dorpaul wrote:
> Hi,
> I am fitting a new Wizard Radiator into my TR3. It's gonna be a tight fit
> unless I slightly lean it towards the driver. In other words, the top of
> the radiator leans backwards (I have installed an electric fan), and is
> only leaning about an 1" closer to the driver than the bottom of the
> radiator. This insures that the radiator cap on the radiator's neck has
> sufficient clearance from the bonnet when it's shut.
>
> Is this allright for my driver TR3?
>
> Thanks,
> Paul Dorsey
> 60 TR3
Paul,
I dont have an answer to your question but the base mount will be at an angle.
Just doesnt sound correct to me. But I have seen radiators on stock and race
cars that are installed about at a 45 degree angle. I believe some of the
Corvette cars used an angled radiator.
Anyway, I just measured a stock TR3A radiator and the height is 22 3/4 inches.
I put a level on the top to measure the bottom to the radiator cap and the
length is 25 3/4 inches. The spout comes out at an angle. Maybe your spout
angle is to steep?
Bob
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|