I think he's measuring the 'chord' of the arc made by the edge of the metal
piece, so the difference is in the width of the metal presented to the
terminals inside the cap. If so, the circumference of the swipe could be
more or less the same.
Geo
----- Original Message -----
From: "Randall" <tr3driver@ca.rr.com>
To: "'J.C. Hassall'" <jhassall@blacksburg.net>; "'TR list'"
<triumphs@autox.team.net>
Sent: Sunday, January 20, 2008 9:38 AM
Subject: Re: [TR] TR4 distributor rotor size?
> However, if I understand you correctly, you're saying that the tip of one
> rotor only describes a 1" circle as it turns, while the other goes 1-3/4",
> right ? 1" sounds way too small to me, 1-3/4" might be about right. Try
> measuring inside the cap.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|