There is only one Dzus locked down ( right one) ---1) check the height of
the gizmos the Dzus fastners lock on to -they have shims ( rubber )
underneath to set the height --2) the hood may be bowed in the center--I
put a couple of 2x4 s( short pieces) under each front corner --and gently
pushed and checked to see if I had de-curved the front edge of the hood. (
bonnet). also check the hood lifter that gets out of whack and does not
retract fully and bends the hood. Thats my take.MikeTR2inLA
> [Original Message]
> From: Paul Dorsey <dorpaul@negia.net>
> To: list <triumphs@autox.team.net>
> Date: 1/10/2007 8:21:51 PM
> Subject: [TR] TR3: bonnett / sit on it?
>
> I am looking at a familiar sight: the bonnett sticking up when it is
closed.
> I am looking at it on Ebay
>
>
http://cgi.ebay.com/ebaymotors/Triumph-Triumph-TR-3-A-1961-TR-3-A_W0QQcmdZVi
e
> wItemQQcategoryZ6469QQihZ013QQitemZ230074713186QQrdZ1
> Granted, this example proably is not even bolted down.
> But, how does one avoid their TR3 bonnett's edge from showing?
> Thanks,
> Paul Dorsey
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html
>
> === This list supported in part by The Vintage Triumph Register
> === http://www.vtr.org
>
> === Help keep Team.Net on the air: http://www.team.net/donate.html
>
> === unsubscribe/change address requests to majordomo@autox.team.net
> === Archives at http://www.team.net/archive
> === http://www.team.net/the-local
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|