In a message dated 6/3/2006 10:42:59 AM Central Standard Time,
trmarty@glwb.net writes:
> Does anybody have a front a-arm upper and or lower out of their car that
> they could measure the width of the socket where the bushings fit with a set
> of micrometers or calipers? I am looking for TR6 but I believe the TR4 is
> the same (maybe). I want to double check a calculation and don't really
> want to take the car apart if I don't have to.
>
The unit I pulled from my junk b... er spares supply measures 1.04 in or
26.4mm.
Dave
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|