triumphs
[Top] [All Lists]

RE: regaining the liner projection

To: "triumph list" <triumphs@Autox.Team.Net>
Subject: RE: regaining the liner projection
Date: Mon, 27 Dec 2004 08:56:50 -0800
>  Already, wrench sockets or large washers have been used to keep the liners
> and steel Fo8 gaskets temporarely in their place in the block. My yet to be
> applied head gasket is made of a composite-copper/?asbetos.  My question is
> this: when I release the three socket/washers, will the liners rise up and
> regain the the desired projection?

IMO it's very unlikely you've applied enough force with sockets & washers to
compress the Fig 8 gaskets enough to measure.  If the liners aren't sufficiently
proud of the block now, they won't rise after releasing the clamps.

Even with all the clamping force applied by the head, the liners still remain
somewhat proud of the block ... the stock composite head gasket compresses more
over the liners than it does over the block.

I believe the original Fig 8 gaskets were copper ... the plastic coated steel
ones were an aftermarket product.  I suspect they were only cheaper, not better.

Randall




<Prev in Thread] Current Thread [Next in Thread>