Subject: | Re: brake pipes to wheel cylinders |
---|---|
From: | "T. S. White" <tswrace@pacbell.net> |
Date: | Sun, 29 Feb 2004 07:09:39 -0800 |
Cc: | triumphs@autox.team.net |
References: | <NCBBKDNEEKEOHAOIIOIIAEKFGKAA.ryoung@navcomtech.com> |
I have always used the tool I was taught to be correct for the square plugs. A 12" cresent wrench. > I've mentioned this before, this seems like a good time to do it again ... > don't use an open-end wrench or a 6 or 12 point socket or box end wrench to > turn those square pipe plugs. Get either a proper square box-end wrench > (machinery supply houses sometimes have these) or an 8 point socket (got > mine from Sears; Snap-On, Mac, etc. should have them too) -- Best regards, Tom |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Gearbox Tunnel Cover Seal, MotoPsyche |
---|---|
Next by Date: | hydraulic pipes, joe maher |
Previous by Thread: | Re: brake pipes to wheel cylinders, AVALON2455 |
Next by Thread: | Re: TR-6 Rear Hub (Longish), Graham Stretch |
Indexes: | [Date] [Thread] [Top] [All Lists] |