Crabby,
I just read my post and realized I instructed you to do something that
should NOT be done!
You do NOT drill into the body through the rear stiffener bar!! The pop
rivets go through the top and bar but NOT into the body!
I don't know what I was thinking and I apologize for misdirecting you or
anyone reading my post.
Jim Davis
Fortson, GA
CF38690UO
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net] On Behalf Of Jim Davis
Sent: Sunday, August 03, 2003 12:12 PM
To: 'Richard Crabbe'; 'triumphs'
Subject: RE: Snap Position - Repost
Crabby,
Use the rear top (hood) stiffener bar to locate the position of the rear
snaps. The bar has holes for the pop rivet to pass through, so just bolt
it up and drill through the holes. On my car, and I believe there were
slight production variances, the first snap hole on either side is
exactly 2" from the edge of the stiffener bar and the next is exactly 7"
and the front-most snap hole is exactly 7-1/2" from the previous hole. I
assume here that you are fitting a new top, if not align the male snap
locations to the existing female snaps on the top.
HTH,
Jim Davis
Fortson, GA
CF38690UO
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net] On Behalf Of Richard Crabbe
Sent: Sunday, August 03, 2003 10:24 AM
To: triumphs
Subject: Snap Position - Repost
Can anyone advise as to the correct position for the snaps on the back
of a TR6. My upper deck has been replaced and I have no holes for
reference. Is there a specific pattern as to where they go - the center
one then so many inches from there each side. The VTR says 7" from
centers BUT where does that measurement start - center
snap- edges or where.
I have been running around town with my camera and a tape but can't find
a TR6 when you need one.
Thanks
Crabby
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|