> My 250's OD switch engages when flipped down and off when up. The
> manual says
> it should be the other way. I just recently put in a new switch and wiring
> because the old switch was showing its age and the wiring had
> been botched by
> PO's. I was hoping that all would be well now but it is still the
> same. The
> switch is not capable of being turned 180 degrees or I would do that. Any
> thoughts from the list on a cure for this not very big problem?
Hmm, did the TR250 originally have a different switch than the TR5 ? Don't
have my Lucas catalog handy.
If you really wanted to fix it, and there isn't another contact on the
switch, one way would be to add a "normally closed" relay after the switch.
Then it's contacts go in the circuit with the existing relay and isolator
switches.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|