No, some people ream the channels for oversize shafts.
Joe
-----Original Message-----
From: George Richardson [mailto:gprtech@frontiernet.net]
Sent: Friday, June 27, 2003 12:30 PM
To: Joe Curry
Cc: 'Mark Hooper'; triumphs@autox.team.net
Subject: Re: SU carb bushings
I thought that's what everyone did.
Joe Curry wrote:
>I have found that the best way to handle SU throttle shaft bushings is
>to ream out the channel and install bushings for the new hole size and
>ream them out to a standard throttle shaft size. When you get
finished,
>you have a throttle shaft that is not larger than the original one and
>thus will not have a negative effect on air flow through the carb.
>
>
>Joe
>
>
>
>
>
>
--
George Richardson
1957 Triumph TR3 - TS15559L http://www.key-men.com/triumph
1975 Triumph TR6 - Undergoing restoration
1972 Triumph Stag - Daily Driver
Key Men: Keys for Classics - http://www.key-men.com
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|