> Darrell, I have had better luck with the rubber seal, but before you put
> any seal in make sure you check the pinion flange for seal wear. You
> may want to use some crocus cloth to clean up any wear. If its bad,
Note that "bad" is a relative term, in this location I'd say anything you
can catch a fingernail in is "bad". And, I've seen some leak where you
could only see the wear mark, not feel it even with a fingernail. So, I
always dress it with crocus cloth until I can't see the wear mark, or else
put on a sleeve.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|