> I just replace plugs and wires on my 250 today. My dad noticed that it
> smells rich when running.
> Now let me back up. The old plugs that I took out looked good on the
> back 3 cylinders. The front 3 was white. I mean white. Now with the new
> plugs in and car running, pull the wire off one of the front 3
> the car does
> not change. Pull it off the back 3 you notice the motor skipping. Now the
> front carb must be lean. I have adjusted it all the way out and
> after motor
> warm up, no change in motor sound when pulling one of the front 3 wires.
This sounds to me more like a synchronization problem.
> Now my question is , could the back carb be to rich and
> taking away from
> the front carb?
The rear carb might be rich, but it couldn't be "taking away" from the front
carb.
> It will run, but this does concern me since I am getting
> ready for a trip to the 6-Pack Trials in Ohio.
> Any help of other tips to check would be appreciated.
After checking synchronization, check the float level in the front carb.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|