>I glued all of the carpet to the floor that ran over the prop. shaft tunnel
>between the seats
When I got my 3A it still had original carpets in it. The carpet over
the tunnel was kept in place by four snaps as was the carpet on the rear
shelf (post TS60000). SO When I laid the new carpet in I put new snaps
in where the old factory ones were. The piece between the seats justs
rests in place without being fixed down.
> For the area under the seats,
Mine did not have carpets below the seats.
> For the footwell
>I used the remanufactured original type, rubber full floor mats and use the
>original snaps in front of the seats and the original type little clips on
>the fire wall.
Same here
>The carpet is the Moss nylon full carpet set
Same here. It's OK, except I already have a run in the rear carpet piece.
TeriAnn Wakeman Marigold Ltd.
Santa Cruz, California Web design, site updating, testing
webmaster@overlander.net search engine optimization, graphics
and more
http://www.overlander.net/Marigold/index.html
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
|