Trevor and all-
Ok. You're corerct, with 0.006"-0.008". I'm at 0.008" any concerns at
this level?
Thanks-
Pouya
On Sun, 17 Sep 2000 08:12:11 -0700 Highway Star <highwaystar@juno.com>
writes:
> Sorry, I have a "0" outta place:
>
> Is 0.0048"-0.011" the correct tolerance? (my mechanic says it is).
>
> Trevor are you're numbers correct!? Just had thrust washers replaced
> and the end float according to my mechanic is 0.008". Help?...is
> this good?...where is ideal?...end of the spectrum is NOT to me!?
>
> Thanks-
> Pouya
>
> On Sun, 17 Sep 2000 21:09:00 +1100 Trevor Jordan
> <tjordan@bigpond.net.au> writes:
> > At 7:06 AM -0700 15/9/00, Highway Star wrote:
> > >Folks-
> > >
> > >Can someone please confirm end float spec for a TR6 is
> > 0.0048"-0.0011"?
> > >
> > >Thanks-
> > >Pouya
> > >________________________________________________________________
> > >http://dl.www.juno.com/get/tagj.
> >
> > No, the crankshaft endfloat should be 6 to 8 thou.
> >
> > Trevor Jordan
> > 74 TR6 CF29281U
________________________________________________________________
http://dl.www.juno.com/get/tagj.
|