Sorry, I have a "0" outta place:
Is 0.0048"-0.011" the correct tolerance? (my mechanic says it is).
Trevor are you're numbers correct!? Just had thrust washers replaced and
the end float according to my mechanic is 0.008". Help?...is this
good?...where is ideal?...end of the spectrum is NOT to me!?
Thanks-
Pouya
On Sun, 17 Sep 2000 21:09:00 +1100 Trevor Jordan <tjordan@bigpond.net.au>
writes:
> At 7:06 AM -0700 15/9/00, Highway Star wrote:
> >Folks-
> >
> >Can someone please confirm end float spec for a TR6 is
> 0.0048"-0.0011"?
> >
> >Thanks-
> >Pouya
> >________________________________________________________________
> >http://dl.www.juno.com/get/tagj.
>
> No, the crankshaft endfloat should be 6 to 8 thou.
>
> Trevor Jordan
> 74 TR6 CF29281U
________________________________________________________________
http://dl.www.juno.com/get/tagj.
|