I made a tool to remove and replace the cam bearings on my TR3, and it
worked, but if I were to do it again, I'd either get the right tool or
have someone else do it. I spent most of a day just installing them
because I was so worried about damaging them. It was no easy trick
aligning the oil holes either.
a Wallace wrote:
>
> Does anyone know how to get these out without the aid of special Churchill
> tool #xyz?
> Thanks,
> Jim
--
George Richardson
Wyvern - '57 Triumph TR3, TS15559LT -
http://www.merlingroupinc.com/tr3.htm
Griffin - '71 Triumph Stag - undergoing restoration
Pikachu - '75 Triumph TR6 - undergoing repair
Kitty - '83 Jaguar XJ6 Vanden Plas - Daily Driver
|