Fred,
I still can't figure it out. There are two small holes in the aluminum
pieces (maybe a little over 1/2" apart), but I can't find any corresponding
holes in the stanchion. I'm also confused as to how that left over part of
the bottom rubber sealer gets routed.
Thanks (again),
Dave
>-----Original Message-----
>From: Fred Thomas [mailto:vafred@erols.com]
>Sent: Saturday, September 02, 2000 5:29 PM
>To: David Moag; Dennis & Bridget Lambert; Triumphs
>Subject: Re: TR-3A windshield installation
>
>
>Dave, the little triangle piece of aluminum goes in the very center rear
>part of the stauntion and holds the end of the weather stripping that comes
>along the botton of the w/s frame, should be 2 holes in the alum. peice as
>well as the staunction, sitting in the drivers seat and looking into the
>staunction you can see where the alum. piece is attached (after you install
>it) "FT"
>> I've got little brackets that attach the tennon plates to the stanchion.
>> Then I've got these little corner plate things that I haven't figured out
>> what to do with yet. If I figure this out this afternoon, I'll let you
>know.
>>
>> Dave Moag
>> 62 TR3B
>> 77 Spitfire
>> La Canada, CA
>>
>> >-----
>
|