It's definitely not metric.
Surely the big 3 get them from someplace. Could it be that Charles subs out
the cutting, drilling, and tapping of bar stock? It seems pretty unlikely.
It also seems unlikely that they'd want to advertise their source(s).
Jim
Donald H. Locker wrote:
>I just ran into a need for the dreaded 1/4-28 square nut. And haven't
>found a source for them. I may just cut some steel stock and drill
>and tap it. (fortunately, I only need two, but it is definitely 1/4-28)
>
>Donald.
>
> > From: "Brad Hofmann" <blhjr@amaonline.com>
> >
> > Jim
> >
> > I have had these quoted all over the States and nobody
> > carries a 1/4 square nut in a fine thread. Are you sure
> > you aren't looking for a metric size? Sorry I haven't
> > had better luck.
> >
> > Brad Hofmann
> > Amarillo, Texas
> >
>[initiating message snipped; Jim needed a HUNDRED!]
|