Buy a piece of bar stock ad make your own, they fit better than the
replacements... (If you buy the right stock)
T.R. Householder
"If it's not broke don't fix it".
"If someone made it you can fix it"
"You say it's not available.... make it!!!"
Brad Hofmann wrote:
> Jim
>
> I have had these quoted all over the States and nobody
> carries a 1/4 square nut in a fine thread. Are you sure
> you aren't looking for a metric size? Sorry I haven't
> had better luck.
>
> Brad Hofmann
> Amarillo, Texas
>
> ----- Original Message -----
> From: "a Wallace" <wallaces@superaje.com>
> To: <triumphs@autox.team.net>
> Sent: Thursday, June 29, 2000 10:19 PM
> Subject: 1/4 x 28 square nuts
>
> >
> > A while back I went looking for these nuts for my TR3a, to no avail. (They
> > are the ones that rattle around inside cages, and are used to hold many
> > parts of the body together.)
> > Does anyone know of a source of these, apart from the big 3? I need about
> a
> > hundred and it just is too hard to buy them one at a time for ten times
> > their worth, on principle. Also, I'd like galvanized or stainless if they
> > can be had.
> > TIA,
> > Jim Wallace
> >
|