Re: 1/4 x 28 square nuts

["Donald H. Locker" <dhl@chelseamsl.com>]

I just ran into a need for the dreaded 1/4-28 square nut.  And haven't
found a source for them.  I may just cut some steel stock and drill
and tap it.  (fortunately, I only need two, but it is definitely 1/4-28)

Donald.

> From: "Brad Hofmann" <blhjr@amaonline.com>
> Date: Fri, 7 Jul 2000 01:31:54 -0500
> 
> 
> Jim
> 
> I have had these quoted all over the States and nobody
> carries a 1/4 square nut in a fine thread. Are you sure
> you aren't looking for a metric size? Sorry I haven't
> had better luck.
> 
> Brad Hofmann
> Amarillo, Texas
> 
> 
[initiating message snipped; Jim needed a HUNDRED!]