Roger,
I would venture to guess that your master cylinder is not adjusted correctly, or
your "restrictor valve" is mal-functioning. You should only have only a slight
drip when a bleed screw is loosened until the restrictor valve spring releases
its pressure and fluid. Your rotors should spin with ease while the tire is
attached only a slight pad rubbing. The restricter valve keeps some pressure on
the pads so you dont have to pump up to get the pads in initial contact with the
rotor. I see the restrictor valve is N/A at moss and trf but you may find one at
one of the places that sells used stuff. I have never taken one apart but it
looks like it can be dis-assembled.
Check them out.
Bob Labuz
1958 TR3A
1974 T140V
Roger Colson wrote:
> Hello fellow listers,
>
> I am now able to drive my TR3 under it's own power. Spent most of the
> morning adjusting the mixture. Some first timer mistakes slowed me
> down.
>
> A major problem is that I believe the brakes appear to be locking up
> after a short trip. After about 200 feet they start to bind and then shortly
> there after the engine bogs down trying to move the car. After waiting
> the car will roll again but then go through the same routine. Last time I
> noticed that the brake pedal was hard, so I looked and the brake lights
> were on. So I opened one of the caliper bleeders and a small amount of
> brake fluif spouted out. I was then able to get the car back in the
> garage.
>
> The brakes have been done over this winter. New master cylinder.
> rebuilt calipers. SS pistons. New pads. SS hardlines. SS braided
> hoses. New rear cylinders. New rear shoes. The rotors were fine, with
> lots of metal left, and the drums were like new.
>
> What I would like help with is in trying to diagnose and repair this
> problem.
>
> What would cause the brake pressure to build up? Several times I did
> not even touch the brake pedal.
>
> What I plan on checking is:
>
> What appears to be rubbing.
> Could the pads be too thick? The rotors were hardly worn. The pads
> were a little snug when installing.
>
> Could the caliper be off center? Forcing one pad to always be in
> contact.
>
> I will re-check the rear brake adjustment.
>
> As I write this message I am thinking of more things to check.
>
> Is there freedom of movement in the hand brake pawls with the hand
> brake off?
>
> If I need to, I will pull the rotor and have it checked for truth.
>
> I won't be able to get to the car until Tuesday evening. So I can read
> responses sent directly to the list in the list digest.
>
> Thank you,
> Roger
> Hoping to make it to the show Fathers Day.
>
> Roger Colson
> 57 TR3 TS21383L
> sassamon@mediaone.net
> http://people.ne.mediaone.net/sassamon/TS21383L
|