you can contact Classic Tube at 800-882-3711 or www.classictube.com.
they offer both stainless steel or original equipment steel for tr6
brake, clutch, and fuel lines.
great help over the phone and the tubes are pre-bent and finished with
the proper fittings. haven't used them yet but i'm confident they'll
work and look great.
stainless steel brake line set will run you $200, original equipment
will cost $175. clutch is $25 and $20 and fuel is $60 on original, not
sure on stainless.
i didn't check with the "big 3", as i'd kept an email thread
recommending this source. good luck!
Tom Di Iulio
1976 Tr6 (rising like the griffin!)
Denver, Co.
McGaheyRx@aol.com wrote:
>
> In a message dated 99-07-21 20:13:52 EDT, slevine@toucan.com writes:
>
> << I am in the process of replacing the fuel, bake and clutch pipes on my
> 70TR6 with stainless steel. I have 2 questions -- >>
>
> Sorry I don't have the answers - just a couple of questions -
> Where did you get your stainless steel pipes ? Were they prebent ? correctly ?
> and - if you don't mind - how much were they? how long did it take to get
> them ?
> I'm currently stripping my 73 TR6 frame - will be looking for brake and fuel
> line
> replacements RealSoonNow - i hope.
> Any recomendations or advice welcome.
> Cheers
> Jack Mc
|