Andy :
If what you're looking at has an OD of about 13/16" (.813") then it's a
sleeve. The pin is only about 5/8" (.625") in diameter. Mine came off
with a bit of twisting with pliers.
I'd probably use a Dremel cutoff wheel to slit the sleeve lengthwise as
much as possible, then a cold chisel and BFH to finish spreading it.
Randall
59 TR3A "daily driver wanna be"
Andy Dixon wrote:
>
> Are these metal sleeved? They appear to be (and sleeves came with the kit)
> but are resisting all means of removal. If they are, anyone got any tried
> and true methods of removal before I resort to the torch and air chisel
> method?
> Thanks,
> Andy
|