Craig wrote:
>Triumphant Listers, A question for any of you that may have had the Falcon
>Stainless Steel Twin Sports exhaust system on a TR-6. I've got the pretty
>system in my hands and was wondering what you may have done for rear
>hangers. I noticed in the Moss catalogue that its says "The system uses the
>standard support ...... only the mufflers need different rear mounts" It
>goes on say that these are included in their fitting kit (yeah right). TRF
>says "it will be necessary to improvise rear hangers". Now if it were up to
>me I'd be getting out the PIG (Plutonium Inert Gas) welder, going down to
>the local unobtainium store, and securing a ride on the next space shuttle
>to "improvise " my rear hangers. Seriously I'm just looking for some
>suggestions or past experiences that any of you may have had in installing
>this particular system. Please bear in mind that what I've got sitting out
>in the garage is just a frame with all suspension and running gear bolted
on
>so I'm not exactly sure what space clearances I'll need as far as clearing
>the rear body work is concerned. Any input would be greatly appreciated.
I have the dual Falcon S.S. exhaust system on my 73 TR6 with dual ultraflow
S.S. mufflers. The mufflers are spaced so that hang from the muffler outlet
pipes. Work was done by a muffler shop.
Martin Gonzales
73 TR6
San Jose, CA
|