I'd like to join this discusion. I have a tr4 that the starter kept
hanging up on. I think all the wires are correct, the battery was new
when this began. I losened the starter and it disengaged from the
flywheel, after doing this several times I started the car with the
starter not fully tightened to the engine/tranny. I tried several shims
without success , finally in desperation I placed a washer on one side
of the starter and tightened the bolts. This forced the starter into a
kittywhompus postion,but it seems to work. I think something must be
bent , I tried aouther used starter with the same results. I don't like
the way it is. Any ideas ?
|