My factory workshop manual doesn't specify a dwell angle.
Timing should be 4 BTDC, point gap 0.015. If you can figure
a dwell angle from this, I'd be interested to know.
At 04:00 PM 8/19/98 EDT, CarlSereda@aol.com wrote:
>
>Since 1974 I always tuned my engine by using the 'basic setting' with no real
>difficulty but lately I am suspicous about my less than perfect ditributor
>shaft (a little play there). In the newer books is there a dwell spec? for
>that matter does anyone have the numbers to use with a timing light too? My
>old book (TR4-4A Autobook) recommends static setting (as distrib has weights)
>and of course the crank pulley has just a TDC hole and no numbers but I am
>curious to check both these areas. Any info appreciated.
>Carl
>'64 TR4
>
>
Cliff Hansen
chansen@exis.net
1966 TR-4A CTC 64615L
|