I didn't measure the diameter directly since I don't have a hole micrometer.
However I inserted one end of a new shaft (the longer of the two) in one of
the bushings and measured the end play at the other end. Rather than give
you numbers that might be in error let me see if I can measure the end play
again. The shafts were visually worn, I'll dig them out of the trash and
measure them too.
Later
lee
> ----------
> From: James
> Sent: Monday, April 20, 1998 7:33 AM
> To: Janssen, Lee K
> Cc: 'triumphs'
> Subject: Re: TR6 carb shafts
>
> Out of curiosity did you take a micrometer to them, to work out the ware
> on the bore compaired to the ware on the spindel.
>
> --
> James Carpenter
> Yellow '79 spit wired by a trained marmot
>
|