Rick,
I purchased three different sizes: standard, .050, and I think .0025
oversize. You may have to use two different sizes to get the end float
right.
You could probably drive it for a while at .010, but it is an easy job, and
there's something to be said for peace of mind.
Good Luck!
Chad Stretz
73 TR6
CF7511U
rick wrote:
> Folks, crankshaft end-float on my TR6 is .010. Recommended is .06/.08...
> What to do? Install new standard sized thrust washers? Oversized (in what
> increments?)? or leave it at that?
> Help would be appreciated...
>
> Thanks!
>
> rick
> 72 TR6
|