| To: | MILESJE@novell2.bham.ac.uk |
|---|---|
| Subject: | Re: Valve stem oil seals... |
| From: | WINDOWSEET@aol.com |
| Date: | Fri, 12 Sep 1997 22:27:41 -0400 (EDT) |
| Cc: | triumphs@Autox.Team.Net |
The seals that Kipping supplies are probably right for the engine but the valve guides have to be machined with with a groove to retain them. It is also possible that the tops of the valve guides have to be reduced in diameter. This can be done by a competent machinist with the guides installed in the head. Greg Wolf 1970 GT+ "Ian" Ann Arbor, Michigan Winnipeg MB Canada |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Valve stem oil seals..., WINDOWSEET |
|---|---|
| Next by Date: | Re: O/D 3-RAIL J-TYPE TRANS FIT HERALD?, Andrew Mace |
| Previous by Thread: | Re: Valve stem oil seals..., WINDOWSEET |
| Next by Thread: | thrust washers, karim.marouf |
| Indexes: | [Date] [Thread] [Top] [All Lists] |