-- [ From: Chris Reilly * EMC.Ver #2.5.3 ] --
Michael;
I am just finishing up this particular project, although I opted for
fully replacing
the switch with a race type setup mounted in the radio bracket on my
spitfire.
Don't have the diagram handy, but I can send you the wires needed for
just the
starter circuit... oh... do you have a triumph spitfire ? Hope to have
pictures of
the finished work on a site someday...
Chris
It's official if I EVER sell this car I WILL be a DPO...
'78 Spitfire ( electrical project almost completed )
-------- REPLY, Original message follows --------
> Date: Monday, 16-Jun-97 04:39 PM
>
> From: Michael D Fatsi \ PRODIGY: (WEZA65A)
> To: Triumph List \ Internet: (triumphs@autox.team.net
)
>
> Subject: Ignition Wiring
>
> I have had some trouble with my starter switch. I have had bad luck
as this
> will be the third ignition switch that I have gone through in seven
years. I
> have decided to take an alternate path to fixing this problem. The
solution I
> want to go with is a push button switch. I have looked at the wiring
diagram
> and it is not immediately obvious how this should be wired up. I plan
to leave
> the current keyed ignition switch in place and use it merely as a on
/off -
> column lock.
> Any suggestions on how I should proceed.
> -MF
>
-------- REPLY, End of original message --------
|