On Tue, 20 May 1997 09:58:23 -0400 peb3@cornell.edu (Philip E. Barnes)
writes:
>Good morning:
>I am finishing the last of the detail work on my car, and am ready to
>install the sill trim (that polished strip just below the door). I
>have the
>rivets/clips that hold it on, but I am wondering how the strip gets
>held
>there. Do I slide the strip over the clips after they are installed,
>or
>does the strip snap over them? I'd rather not mess this up. Any
>helpful
>suggestions are appreciated.
>
>Phil Barnes
Phil,
The strip just snaps over the studs. Place the trim strip in its position
and give it a sharp slap with your hand. It will snap over the stud. If
you try to slide the strip on, you will just scratch the paint and bend
the strip.
Larry Miceli
'76 TR6
'73 Stag
'66 Herald
|