To: | triumphs@Autox.Team.Net |
---|---|
Subject: | TR3 Carb Question |
From: | Jay Wassall <wassallj@philly.infi.net> |
Date: | Mon, 17 Feb 1997 12:19:59 -0800 |
References: | <3307741B.74BB@autox.team.net> |
I am getting ready to rebuild the carbs on my TR3A for the first time. I noticed the jet levers (choke) are very sloppy where the pivot pin goes through them. I looked at the levers and the hole is not elongated, it is just much larger than the diameter of the pin that goes through it. This is the same on both carbs. Is this normal? _ _ | \ / | | \ / | | \_/ | | | | 1959 TR3A TS42661L | | | | | | __| | |__ | | | | | \T \___|___/ H/ \ R I U M P / --------- |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | TR3A Carb Question, Jay Wassall |
---|---|
Next by Date: | Re: TR6 SPARK PLUGS, Paul Burr |
Previous by Thread: | TR3A Carb Question, Jay Wassall |
Next by Thread: | Re: TR3 Carb Question, Carl Musson (EVENTS) |
Indexes: | [Date] [Thread] [Top] [All Lists] |