As to whether it is normal or not - I dunno. But, mine are the same.
Anyone else?
later...
/------------------------------------------------------------------------\
| CARL F. MUSSON, Coordinator INTERNET:musson@arts.usf.edu |
| Tampa, FL Opinions expressed are mine and not of my employer.|
\ '58 TR3A (TS25264L) - http://www.arts.usf.edu/~musson/triumph/ /
On Mon, 17 Feb 1997, Jay Wassall wrote:
> I am getting ready to rebuild the carbs on my TR3A for the first time.
> I noticed the jet levers (choke) are very sloppy where the pivot pin
> goes through them. I looked at the levers and the hole is not
> elongated, it is just much larger than the diameter of the pin that goes
> through it. This is the same on both carbs. Is this normal?
>
> _ _
> | \ / |
> | \ / |
> | \_/ |
> | | | 1959 TR3A TS42661L
> | | |
> | | |
> __| | |__
> | | | | |
> \T \___|___/ H/
> \ R I U M P /
> ---------
>
|