TR3A Carb Question

[Jay Wassall <wassallj@philly.infi.net>]

I am getting ready to rebuild the carbs on my TR3A for the first time.
I noticed the jet levers (choke) are very sloppy where the pivot pin
goes through them.  I looked at the levers and the hole is not
elongated, it is just much larger than the diameter of the pin that goes
through it.  This is the same on both carbs.  Is this normal?

    _       _ 
   | \     / |
   |  \   /  |
   |   \_/   |
   |    |    |           1959 TR3A TS42661L
   |    |    |
   |    |    |
 __|    |    |__
|  |    |    |  |
 \T \___|___/ H/
  \ R I U M P /
    ---------