Jack Brooks may have said...
The basics are as follows and it really isn't all that expensive, two
layers of epoxy paint and a bit of fine sand. The first coat of epoxy is
squeegied and then rolled on, the sand is sprayed uniformly, fully
coating the surface and allowed to dry for 12-24 hrs. With clean shoes,
vacuum up all of the sand, the re-squeegie and roll the surface. You end
up with a sealed, mildly abrasive but easy to clean floor.
To which I might add...
Make sure that you put the sand on the floor. That nice shiny grey
epoxy floor by itself is slicker than owl sh*t! I have knots on my
head to prove it!
Dan
--------------------------------------------------------------------------
The old wrench said:
I'm not a fast mechanic,
I'm not a slow mechanic,
I'm just a half-fast mechanic!
----------------------------------------------------------------------
|