<< How does one use the the 12v light bulb and clips i.e. how do you
know when you're at 10 degrees BTDC >>
The light bulb goes on. <g>
Okay, I know. I'm a smartass. Basically, you hook the bulb between the
coil and battery. Rotate the crank till your at 10° BTDC, then turn the
distributor counter-clockwise till the light comes on. Then turn the
distributor clockwise till the light goes out. Tighten everything down,
replace the coil wire, and off you go.
It's a little more complicated than that, but not much more.
Robb Baugher
73' Stag
Marco Island, FL, USA
|