Sandy,
Have you run across the issue of "wimpy" roll pins?
bt
----- Original Message -----
From: "Sandy Ganz" <sganz@pacbell.net>
To: "Dave Munroe" <dave@munroe.ca>; "Smit, Theo" <Theo.Smit@dynastream.com>;
<tigers@autox.team.net>; <Gyroplanes@aol.com>
Sent: Friday, June 11, 2010 10:37 AM
Subject: Re: [Tigers] What do I do now?
>I think you need to check the install height of the gear from what I have
>seen on some other ford boards as some of the MSD's have the gear on where
>it may not be at the right install height, the last 2 Ford MSD distributors
>I purchased had a warning to verify install clearances or expect and early
>gear demise.
>
> I have a composite gear and will see how that work on the motor going in
> the mustang with a solid roller. Looked iffy but had many people say they
> are better then the bronze (never had a problem, but only used on a track
> car).
>
> Sandy
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|