Hi all,
Randy Willett also has high quality repair sections sent out from the UK
which may well be the same as the ones at VB.
I have used the same panels in the UK on several cars very successfully.
randy willett <willett581@msn.com>
regards
Jeff
In message <000001ca2737$51d81280$f5883780$@rr.com>, Samouce's
<wsamouce@kc.rr.com> writes
>I called Bob recently to inquire about a steel LAT hood. He told me is so
>many words that I did not have enough money for him to make me one.
>
>I recently replaced my front valance with a VB unit. It was a good fit.
>
>HTH's
>Duke
>B382002037
>
>-----Original Message-----
>From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
>On Behalf Of robin02@mindspring.com
>Sent: Thursday, August 27, 2009 11:43
>To: Baker,Kent; tigers@autox.team.net
>Subject: Re: [Tigers] Tiger Sheet metal
>
>KEnt, I spoke to Bob Martel about five years ago when he was moving away
>from the Sunbeam fabrication efforts. HE was selling some things he still
>had already made but was not doing any more. It was Bob that told me that
>Victoria British had a good supplier for body panels from ENgland and the
>fit was good. LArry Paulick later confirmed this and I bought ten body
>panels for my car; front and back of each wheel well and the outer rocker
>panels. THe inner rocker panels were fabricated by my body, paint man. THe
>fit was good and my car turned out without any evidence of patch panels. At
>the time, neither Rick not Curt could fill the order. RObin Young
>
>---Original Message-----
>>From: "Baker, Kent" <kentb@qualcomm.com>
>>Sent: Aug 26, 2009 1:14 PM
>>To: "tigers@autox.team.net" <tigers@autox.team.net>
>>Subject: [Tigers] Tiger Sheet metal
>>
>>I am finally getting to the complete restoration of my MK1a, and am looking
>>for quality sheet metal replacement parts. Although a Southern California
>>car, it has rust on the frame exhaust pass through and a few pin holes on
>the
>>floorboards immediately above. The shop doing the frame welding contacted
>>Martell in Ontario, but he is out of the Tiger sheet metal business. I
>noticed
>>Classic Sunbeam Auto Parts has the exhaust frame patches listed on its
>parts
>>sheet, but have no experience (yet) working with them. Suggestions for
>>sources? The car is in Reno, Nevada, although I live in San Diego.
>>
>>Kent Baker
>You are subscribed as wsamouce@kc.rr.com
>
>Tigers@autox.team.net
>http://autox.team.net/mailman/listinfo/tigers
>
>http://www.team.net/archive
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>You are subscribed as jeff@v8tiger.demon.co.uk
>
>Tigers@autox.team.net
>http://autox.team.net/mailman/listinfo/tigers
>
>http://www.team.net/archive
>
--
Jeff Howarth
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|