Tim, I went with Wilwood front and rear caliber's, and made my own
brackets. Honda rotors on rear. Used Wilwood spot ebrake.
Larry
Ronak, TP (Timothy) wrote:
>Listers,
>Dale A. Has suggested to use the 1981 Subaru Master Cylinder with a
>13/16 inch bore. Has anyone else done this and did they have a source
>(brand and part number) that could supply them with the reservoir. Has
>anyone else used a different master with good success? I am looking into
>using Mustang rear calipers and the kit dale sells to upgrade to vented
>rotors in the front. I do not want a race car braking system just
>something a little better than stock.
>Anyone have some input or photos of their master setup.
>I have checked into the Fiat rear calipers but they are hard to find $$$
>and the mustang version may create a lower cost alternative. Dale has
>indicated he might consider a mustang rear kit.
>
>Best Regards,
>
>Tim Ronak
>Business Development Manager
>Akzo Nobel Coatings
>23961 Via El Rocio
>Mission Viejo, CA 92691
>Off: (949) 305-5393
>Fx: (425) 955-6268
>Cell: (949) 289-3357
>Business email: timothy.ronak@crna.akzonobel.com
>Personal email: timronak@cox.net
>VM: (800) 234-6747 ext. 2257#
|