Listers,
Dale A. Has suggested to use the 1981 Subaru Master Cylinder with a
13/16 inch bore. Has anyone else done this and did they have a source
(brand and part number) that could supply them with the reservoir. Has
anyone else used a different master with good success? I am looking into
using Mustang rear calipers and the kit dale sells to upgrade to vented
rotors in the front. I do not want a race car braking system just
something a little better than stock.
Anyone have some input or photos of their master setup.
I have checked into the Fiat rear calipers but they are hard to find $$$
and the mustang version may create a lower cost alternative. Dale has
indicated he might consider a mustang rear kit.
Best Regards,
Tim Ronak
Business Development Manager
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691
Off: (949) 305-5393
Fx: (425) 955-6268
Cell: (949) 289-3357
Business email: timothy.ronak@crna.akzonobel.com
Personal email: timronak@cox.net
VM: (800) 234-6747 ext. 2257#
This message, including attachments, is confidential and may be
privileged. If you are not an intended recipient, please notify the
sender then delete and destroy the original message and all copies. You
should not copy, forward and/or disclose this message, in whole or in
part, without permission of the sender.
|