Steve wrote:
"You just need a new layshaft, and 1, 2, an 3 gears. Rebuild any bad
bearings or
blockers, and use new seals. Not an expensive job."
Steve, Unless I was looking in the wrong place at a Toploader site I saw
prices of $125-$150 for each of the gears and I think it was $175 for the
counter gears. Even on the low side this comes to over $550 and the syncros
and bearings etc. have yet to be added in. Should labor be a factor then
$$$.
Of course dipping into the Twin's College fund may be a source of finance
for you, but some of us are not so well prepared for the future. Making a
point and a joke at the same time. Tom Witt B9470101
P.S. You missed roll call in Ventura this past weekend.
|