Greetings,
It has been some time since I posted anything here.
Had my Tiger at Chicago RediStrip in queue far too
long. Getting ready to load it up on the rotisserie
and treat it to some new(er) metal.
I understand that some Tigers were available with a
Dana 44 rear end (?). This may be a dumb question,
but did the Dana differential fit into the standard
(Sterling is it?) housing? Or was the Dana a
completely different rear end housing setup? I am
wanting to go with a positraction rear end with around
3.23:1 or 3.50:1 gears as I rebuild the car. The next
question is, "where might I scare up something like
this?".
Thanks in advance for the help.
Gene
=====
Gene Sokolowski
4845 Crestview Dr.
Sioux City, Iowa 51104
(712) 239-4718
B9472068
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/
|