Mark, Cliff,
An important consideration when getting the cross-member reinforced is to
make sure it is straight. This is particularly difficult on this piece
because there is no easy reference point. If the alignment is correct,
especially camber, then it's probably OK. However, many if not most of
these cross-members will exhibit some sag after lo these many years. I
would ask whomever I had do the work if they have any way to check the
geometry before they start welding. As for where to get the work done, the
possibilities I'm aware of are Dale A., Smitty here in S.D. (he has a jig),
and Tom Hall. You might want to discuss relocating the rack back 1/2" while
you're at it, or even going to the Midget rack (see Dale for this).
Bob
Robert L. Palmer
UCSD, Dept. of AMES
619-822-1037 (o)
760-599-9927 (h)
rpalmer@ucsd.edu
rpalmer@cts.com
|