Steve, Jim,
Here is Jim's original posting:
>I bought a set of clips from Sunbeam Specialties to attach the
>S-U-N-B-E-A-M letters to the front of my Tiger (the PO had glued them on).
>How the hell do you use these clips to hold the letters on? I'm clueless.
>
>
>Jim Pickard
>B9473298
Notice, Steve, that Jim says "front of my Tiger". Now, unless you are
driving a Volkswagen conversion, I believe you're instructions, although
given in exquisite detail, pertain to the wrong end of the car. Perhaps you
could submit supplemental instructions for the front (eyebrow). Thankfully,
the ordering of the letters from left to right remains the same. {8->)
Bob
At 07:06 PM 9/8/98 -0700, Steve Laifman wrote:
>Jim,
>
>It's the reverse of the instructions I posted for removal
>(almost). Clean and wax area thoroughly. Put the letter
>posts in the appropriate holes (The "S" is the left-most
>letter {9->), one letter at a time. There are two
>posts/letter. On the back-side, inside the trunk, slip the
>rubber washers over the chrome posts. Then put the "D"
>shaped metal washers on, with the "flats" facing each
>other. The rectangular speed clips are put on last. The
>bend is to the outside, with the gripping feet the last to
>touch the post. Push them on from both sides of the clip,
>while holding the letter in place. This should be a slip-on
>job and hold firmly at the end of the push. If it doesn't,
>something is wrong.
>
>Be careful with the flatter trunk metal areas, as they can
>take a bend with hand pressure. So support the trunk on the
>doubler panels with wide hands.
>
>That's it.
>
>Oh yes, the next letter is "U". {9->
>
>Steve
>--
>Steve Laifman < One first kiss, >
>B9472289 < one first love, and >
> < one first win, is all >
> < you get in this life. >
>
>
>_/_/_/_/_/_/_/
> _/ _/_/_/ _/_/_/ _/
> _/ _/ _/ _/ _/ _/ _/_/_/_/
> _/ _/ _/ _/ _/ _/ _/
> _/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
> _/
> _/_/_/
>
Robert L. Palmer
Dept. of AMES, Univ. of Calif., San Diego
rpalmer@ames.ucsd.edu
rpalmer@cts.com
|