Ron,
The Edelbrock HI-Po aluminum pump EDE-8442, for the "K" block already has a set
back of casting to hub of 5.16 inches. I guess this matches the Manual, but not
your "corrected" figure published by AE/TE. If I ever have to take my original
pump off, I'm going to measure it. It is a high performance pump and sells for
a dear $150. You can get a polished one (8847) for "only" $239! You can, of
course, replace the hub with your Tiger hub, but I here that the friction fit
betweeen the shaft and is no longer as stong if you do this. Maybe an "Urban
Folklore Tale"? I presume you have made the "adjustments" to the TE/AE
recommendations, and measured pulley alignment. I wonder how accuratly that
measurment can be made? Would you re-adjust your pulley hub if it weren't
"right on"?
Steve
--
Steve Laifman < One first kiss, >
B9472289 < one first love, and >
< one first win, is all >
< you get in this life. >
_/_/_/_/_/_/_/
_/ _/_/_/ _/_/_/ _/
_/ _/ _/ _/ _/ _/ _/_/_/_/
_/ _/ _/ _/ _/ _/ _/
_/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
_/
_/_/_/
|