Whats Up Doc!
Before you fabricate out of billet some steering arms, try MGB steering
arms. You can get them at a wrecking yard for as little as 15 bucks. I
have a set on my car. They do take some fabricating, 1) one of the holes
has to be elongated as the mgb arms holes are an rch narower. 2) you will
need to make two bushings for the forward mounts, the dimentions can be
obtained from the workshop manual. 3) bump steer and ackerman can be
adjusted via a torch and some careful mesurments. It is important that you
know your backspacing of the front rims as this will limit the amount of
correction that you can obtain.
Good luck
Bill Martin
B9470735
|