Allan,
I bought my fan asy in Sept. of '93 from Frontier Ford in Santa Clara,
CA. The part # is FMCC9DZ8600A. Cost was $63.06 list. Ph. # is
408/247-6583. If this doesn't pan out, Norm had a contact at one of
the dealerships in his local as I recall.
I was told that I would need to take from 3/8 to 1/2 inch off of ea.
blade. I took 1/2". Hindsight, I probably could have gotten away
with 3/8". Just needed to pull the lower corners of the fan shroud
out a small amount.
Good luck,
JC
______________________________ Reply Separator _________________________________
Subject: Canadian Fans
Author: Non-HP-alcon (alcon@earthlink.net) at HP-ColSprings,mimegw5
Date: 10/13/97 8:13 PM
Well, finally getting off my keister and employing many of the
recomendations made regarding cooling Tigers.
The radiator is out of the Tiger and will be re-cored with a 4 row Modine
later on this week. Am considering the Edelbrock or Stewart Hi-Po Water
pumps for later on.
In the meantime, I would like to get my hands on one of those 6-blade Ford
Canadian Fans. Have tried many Ford dealers to no avail.....seems as though
the part is discontinued. Did some junk yard shopping this weekend and
could not locate any 69-70 Mavericks with Air Conditioning that had the Fan
intact. Any sources you can offer??? Do ya have one lying around gathering
dust??
Thanks for any help the list can offer. And most importantly, thanks to
all the good advice from the list that has lead to these modifications.
(Including blocking the openings near the horns.....figure it actually
dropped 5 degrees and kept the car cooler, longer, than ever before!)
Regards,
Allan
B9472373 (8-{)>
|