I can verify that Pertronics Ignitor works fine with the stock Tiger
tach. Last spring I installed the Ignitor with the standard coil and
dist. and the tach works okay. The car ran better with the Ignitor
than without.
Jeff
______________________________ Reply Separator _________________________________
Subject: RE: electronic ignitions
Author: "Fraser,Ron" <Ron_Fraser@xn.xerox.com> at INTERNET
Date: 8/20/97 6:30 PM
Steve
Yes I'm still using the original Tiger Tach.
I put the Jacobs electronic system in first, this required the Jacobs
Tach adaptor, which in turn required my original Tach to be adjusted.
Tiger Tom looked at the Jacobs Tach adaptor and built a better one
that should work with any electronic ignition system.
The IGNITOR by it's self only connects to the coil and should not
change the signal to the Tach. I'm only guessing here, I have not
tried the IGNITOR without the Jacobs unit. The Tiger owner who
informed me about the IGNITOR never mentioned having any problems with
his Tach.
Hope this helps.
Ron Fraser
----------
From: Metcalfe, Steven M MED
To: 'Ron_Fraser@xn.xerox.com'
Subject: RE: electronic ignitions
Date: Wednesday, August 20, 1997 2:11PM
Ron,
Do you have the stock tach? Is it compatible?
Steve
> ----------
> From: Fraser,Ron[SMTP:Ron_Fraser@xn.xerox.com]
> Reply To: Fraser,Ron
> Sent: Wednesday, August 20, 1997 11:26 AM
> To: tigers@autox.team.net
> Subject: electronic ignitions
>
> Joe
> I installed the IGNITOR from Pertronics several years ago, it
> works great.
> No points, no condenser, one gap to set then forget about it.
> Install time was about 30 min. Just remove the points and condenser
> and wire the the coil, install the pick up on the plate and run the
> wires through the distributor, put the magnet assembly over the
> distributor cam , and install the rotor, set the gap to .010" to
> .070", connect the wires to the coil, your DONE. The only
> difference from stock look is the red and black wire coming out of
> the distributor.
>
> I know some other people who are also very pleased with the
> IGNITOR
> as a stand along ignition add on. I have a Jacobs electronic
> igntion system with the IGNITOR.
>
>
> Check out the web site for Northern Auto Parts Warehouse to see the
> IGNITOR.
> www.naparts.com under ignition and electronics Ford V8
>
> part #1281
>
> I have seen the IGNITOR listed for Dual point , but it is not listed
> here, I think the number is 1281A. You will have to ask. They
> also have the lowest price listed of any vendor I know about.
>
>
> Ron Fraser B382000009
>
|