Very true. So upon reassembly, one may want to consider putting some
anti sieze where the bulb and nut meet.
Brad
On 9/10/06, Chris M West <chris_west@juno.com> wrote:
> apply it to the nut and give it a rap to TIGHTEN ever so slightly!!
> Re-foam,
> wait, gently try just a little UN-DO. Re-foam, tighten, re-foam and most
> likely it will now just un-do.
>
> Remember that this nut is just like a brake line nut in the it should
> turn INDEPENDENTLY of the tube
> and sender assembly. So not only does the nut need to unthread from the
> radiator, it also needs to
> spin freely on the sender bulb. If you try to twist it out and it is not
> free of the bulb you WILL twist
> (and rupture) the tube, at which point you might as well have snipped it
> off with side cutters!!!
>
> Chris
>
> AN5L35578
--
www.myspace.com/tequilabrad
|