Or you can go to 73.5mm pistons next time for 1380cc. The pistons are
around $400 though...
Ulix (1380 almost ready for assembly)
On Tue, 22 Dec 1998, Peter Samaroo wrote:
> If you go the +060 route you will need to sleeve the engine the next
> time it is due for a rebuild as that is the max size. If you are
> building a high compression engine be sure to take the additional
> displacement into account.
> Regards,
> Peter S.
>
>
> >Date: Tue, 22 Dec 1998 14:57:44 -0500
> >From: Daniel Thompson <dthompso@total.net>
> >To: spridgets@Autox.Team.Net
> >Subject: maximum overbore
> >Reply-To: Daniel Thompson <dthompso@total.net>
> >
> >One more question while I'm all covered in grease:
> >
> >This engine I am working on is +10 on the crank and +40 on the bores.
> >I've believe I have seen +60 overbore and it is my intention to go with
> >that. Any reason why +60 is NOT a good idea? Experiences with failures,
> >cracking, etc?
> >
> >Thanks,
> >
> >Daniel T.
> >
>
>
Ulix __/__,__
.......................................................... (_o____o_)....
'67 Sprite
|